O&O Software DiskImage 5 Professional Edition Guia do Utilizador descarregar pdf (Página 31)

Start O&O DiskImage directly from CD

O&O DiskImage-25

Using the Start CD from O&O DiskImage

Note: The Start CD, designed for running O&O DiskImage without an operating system and for restoring a sys-

tem partition, is not included in the Special Edition.

Note: If you want to run the restoration on a computer with differing hardware, then please read more on the

separate PDF document "Restoration on differing Hardware" (Machine independent restoration). Please see the

notes in the chapters System restoration and Settings for restoration on different hardware.

Loading drivers

If a device like a hard disk or network card isn't automatically recognized when using the Start CD under Windows

PE, it could be that a required driver for the controller (e.g., for RAID) is missing.

You can start loading a new driver immediately after inserting the Start CD using the dialog O&O System settings

and the tab Drivers. You can also find this dialog at a later moment under Start/O&O System settings/Drivers.

Please follow these instructions for loading a new driver:

1. Open the tab Drivers in the dialog O&O System settings as described above.

2. All recognized Windows devices as well as all devices missing installed drivers will be displayed.

3. Select the device for which you want to load a driver.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 95 96

Sem comentários

O&O Software DiskImage 5 Professional Edition Guia do Utilizador Página 31